Build a black-oil PVT table from a separator sample

From oil gravity, gas gravity, temperature and the solution GOR, work out the bubble point, then Rs, Bo and viscosity from 500 to 5,000 psia.

Open in the workbench

Engineering use cases UC-PVT-003 (Build Black Oil PVT Table) and UC-PVT-001 (Estimate Initial Fluid Properties).

BlackOilFluid keeps the correlations consistent with each other: the bubble point, Rs, Bo and viscosity all come from one correlation set (OilCorrelationOptions.Default unless you pass another). WithCorrelations or an OilPresets entry swaps the set as a whole.

Above the bubble point Rs stays at its bubble-point value and Bo falls with pressure through the oil's compressibility; below it gas comes out of solution, so Rs and Bo fall together and the viscosity rises. A table that shows Rs still rising above Pb has the bubble point wrong.

Units are field: °API, gas gravity against air, °F, psia, scf/STB, rb/STB and cP. The temperature is the reservoir's, not the separator's.

Source

using System;
using System.Linq;
using Team76.Engineering.PVT.Facades;

public class S : ICalcScript
{
    public ScriptResult Run(ICalcContext ctx)
    {
        // 35 °API oil, 0.75 gas gravity, 200 °F; 750 scf/STB in solution at the bubble point.
        var oil = new BlackOilFluid(apiGravity: 35, gasGravity: 0.75, temperature: 200);
        var pb = oil.CalculateBubblePoint(750);

        // Rs, Bo and viscosity from 500 to 5,000 psia, the bubble point among the rows.
        var table = oil.GenerateTable(500, 5000, points: 10)
            .Select(p => new object[]
            {
                Math.Round(p.Pressure.Psi), Math.Round(p.Rs.ScfPerStb), Math.Round(p.Bo.BblPerStb, 4),
                Math.Round(p.Viscosity.CP, 3), p.IsSaturated ? "saturated" : "undersaturated",
            })
            .ToList();

        return ctx.Result()
            .Set("Bubble point (psia)", Math.Round(pb.Psi))
            .Set("PVT", new ScriptTable(["P (psia)", "Rs (scf/STB)", "Bo (rb/STB)", "μo (cP)", "state"], table));
    }
}